Spare parts and consumables
Genuine parts for every Aquamatix macerator. The carbon filter should be replaced once a year; everything else lasts the life of the unit unless something that should not go down a toilet went down it.
Carbon filter
HMC01-100-036
The vent filter that stops the smell. Replace once a year; a saturated filter is the single most common cause of a macerator that smells.
Suitable for: All models with a carbon filter
In stock
Non-return valve with elbow, 23/28/32/44 mm
HMC01-XX-015
Stops pumped waste water running back into the tank. A worn valve makes the pump start on its own and the unit smell between uses.
Suitable for: 400 W models
In stock
Blade and blade rack, stainless steel
HMC01-XX-008-V2
The cutting assembly. Replace it if the motor hums without pumping after you have cleared a blockage, or after several years of heavy use.
Suitable for: 400 W models
In stock
Side inlet connectors and covers, set
HMC01-250-143
The rubber connectors and blanking covers for the side inlets. The parts that get cut to size on installation and then get lost.
Suitable for: All models with side inlets
In stock
Shipping: Belgium EUR 5,95, Netherlands EUR 6,95, Luxembourg EUR 6,95. Free over EUR 60,00. Dispatched from Belgium, usually within one working day.
Electrical parts, on Amazon for now
Parts listed on Amazon can be ordered there. For any other part, send the model name and the part number from the exploded view.
Parts Included
Height of Pumping
Device Dimensions
The flow rate of the pump
The exploded view
1. Plastic bottom housing3. Rubber toilet connector
4. Housing sealing
5. Plastic lid
6. Wire + plug
7&9. Plastic small lid
10. Mic switch
11. Motor repair lid
12. Carbon filter
13. Switch housing
14. Plastic clip for switch
15+16.Switch case bottom
17. Plastic filter
18. Blade + blade rack
19. Motor
20. Impeller
21. Diversion plate
22. Diversion pipe
